Wolf ICBCT30I installation instructions C E S S O R I E S

INSTALLATION I N S T R U C T I O N S

MULTIPLE  COOKTOP I N S TA L L AT I O N

If the framed induction cooktop is to be used with any combination of additional cooktop units or modules with a filler strip, the cut-out width is calculated by adding the correspon- ding units’ cut-out dimensions plus 32 mm for each additional unit. Refer to the illustration below.

IMPORTANT NOTE: For Model ICBCT15I/S, the cut-out width should be increased from 340 mm to 356 mm when installed with multiple units.

IMPORTANT NOTE: Unframed induction cooktops are not designed to be installed in combination with other cooktops.

IMPORTANT NOTE: When multiple units are installed side by side, each unit must have its own separate recommended electrical circuit.

When two or more modules are installed together, an integrated module filler strip (IFILLER/S) is recommended. If a 762 mm downdraft ventilation system is also installed, an integrated module support for downdraft ventilation (ISUPPORT) is also required. Contact your Wolf dealer for information on these accessory components.

A C C E S S O R I E S

Optional acces- sories are available through your Wolf dealer. To obtain local dealer information, visit our website, wolfappliance.com.

1518 mm – FOUR MODULES WIDTH OR

1511 mm – 762 mm COOKTOP AND TWO MODULES OR

1276 mm – 914 mm COOKTOP AND ONE MODULE

1130 mm – THREE MODULES WIDTH OR 1124 mm – 762 mm COOKTOP AND ONE MODULE

743 mm

TWO MODULES WIDTH

64 mm

min

356 mm

CUT-OUT

WIDTH

489 mm

CUT-OUT

DEPTH

FRONT OF COUNTERTOP

Countertop cut-out dimensions for installation of multiple cooktops

11