Xantrex Technology SW Series TIME OF DAY 6 MENU HEADING, GENERATOR TIMER 7 MENU HEADING, Page 43

MENU SYSTEM

The ERROR LED can be used to indicate when the generator frequency is well adjusted. When the frequency is within ± 5% of the nominal value, the LED will be off. Once outside this window, the LED will be on. A frequency meter is also provided in the METERS (4) menu heading to allow a more precise adjustment of the generator. It is able to indicate the frequency of the generator only after the inverter has been able to synchronize to the generator. The acceptable frequency range for the SW Series is 53 to 67 Hertz for 60-Hertz models and 44 to 56 Hertz for 50-Hertz models.

Inverter breaker

trippedNO

The inverter’s output AC circuit breaker on the left end of the chassis has tripped or is “open”. Operating too large of an AC load may cause this. Reduce the loads connected and reset the circuit breaker by pressing it in or moving the handle depending upon the type of breaker included.

TIME OF DAY (6) MENU HEADING

Provides the reference for any time functions enabled. Does not reset when the “PRESS FOR FACTORY DEFAULTS” button is pressed. Will reset only if DC power to the inverter is lost.

Set Clock hour 00:00:00

Indicates and allows setting of the hours for the internal clock. This setting is based on a 24-hour clock and adjusts in 10-minute increments.

Set Clock minute 00:00:00

Indicates and allows setting of the minutes for the internal clock.

Set Clock second

00

Indicates and allows setting of the seconds for the internal clock.

GENERATOR TIMER (7) MENU HEADING

Start Quiet
Time h:m	08:00

Generator will not be started during this period unless the actual battery voltage reaches the LOW BATTERY CUT OUT VDC setting for a continuous period of 30 seconds. Causes the automatic generator control system to ignore the AC load and battery voltage start settings. The quiet time period is usually set for the sleeping hours.

End Quiet
Time h:m	08:00

This setting finishes the quiet time period, allowing the generator to start as required by the settings of the GEN AUTO START SETUP (12) menu heading in the SETUP MENU. To disable the quiet time, set the start and end times equal. The generator exercise system will start at this time setting and will run for 15 minutes if the generator exercise timer has reached the SET EXERCISE DAYS menu item setting. For example, if the SET EXERCISE DAYS menu item is set for 1, then the generator will start every day at this time. To disable the generator exercise system, set the SET EXERCISE DAYS menu item to zero.

INFORMATION DISPLAY

The following information is displayed as additional Menu Items.

Gen doesn’t run during quiet time unless batt volts is less than

LBCO volts for 30 seconds, or load > load start amps.

To defeat timers set start = end.

If exercise day set to 1 then gen will always start @ end quiet.

 2001 Xantrex Technology, Inc.	Telephone: 360/435-8826	SW Series Inverter/Charger
5916 - 195th Street N. E.	Fax: 360/435-2229	Part No. 2031-5
Arlington, WA 98223	www.traceengineering.com	Rev. C: February 2001

Page

43