Xerox 2750 Operator’s controls, ½ x 11 C-folded packet, landscape style, Operators Control Panel

Handfeed

Pressing the Handfeed push- button switches the 2750 into hand-folding mode, displaying a modified list of programs. The print to be folded is fed into the rollers at the rear of the folder (image face-down, title block leading - centering is not important, but alignment is).

Folder ON

Models 2753, 2755 and 2757

have similar control panels, with plain language in place of icons, e.g., MORE in place of +>

Receiver Advance Advances conveyor belts on High Capacity Print Receiver, if installed

Indicates a fault/jam condition, or open cover

Operator's Control Panel

Synergix Fold System 40

Operator’s controls

The push-buttons on the operator’s control panel are “soft-programmed”, which means they are used for a number of tasks including selection of the fold program to be applied to incoming prints. The folder firmware includes over 50 fold programs (“tables”), up to 20 of which may be quickly accessed by the operator using the push-buttons. (The fold programs are listed in Chapter 4, and also in the Fold Directory. A separate set of up to 20 programs for hand feeding is also provided.

In most cases the folder is connected to a host controller through its serial interface and when the folder is powered up the display will read ONLINE. If the folder is not connected to a host or the Communications mode is not set to “Normal” the control panel displays the first four fold programs selected for your folder, as in the example below:

1:8.5 x 11 PORT C 8½” x 11” C-folded packet, portrait style

2: *	8.5 x 11	LAND C	8½” x 11” C-folded packet, landscape style
3:	9 x 12	PORT Z	9” x 12” Z-folded packet, portrait style
4:	8.5 x 11	BkaZ	8½” x 11” book-folded packet (Z fold only)

In this sample display, fold program #2 is active, which means the folder will fold every incoming print (other than A-size sheets) into 8½” x 11” landscape packets.

If more than four fold programs have been selected for your installation, press the MORE button to display.

2750 op#2 R3.doc 10-02 Page 2-2