HAND | HANDFEED light off - hand feed program not initiated |
FEED |
|
HAND HANDFEED light on steady - folder is ready to accept a print
FEED
HAND | HANDFEED light flashes - folder is currently folding a print |
FEED |
|
To begin hand feeding ...
1.If applicable to your system, check the printer controller/host computer to make sure no prints are queued to the folder.
2.Press the HANDFEED button. If a fold is in process or a sheet coming command has been set by the controller an audible beep will sound and the HANDFEED button must be pressed again when the system is clear. At this point the LED is a steady green and the folder is ready for hand feeding.
3.On the operator’s control panel, press the appropriate
4.Slide the accessory plate back from the infeed slot.
5.Turn the document face down, positioned so that the title block is nearest to the infeed slot.
6.Keeping the document square to the infeed rollers, slide it gently forward until the infeed sensor energizes the drive system.
During the folding process, the HANDFEED green LED on the operator’s control panel flashes, indicating that the system is busy. Do not try to hand feed another document until the light stops flashing.
Hand feeding a document
Center the document in the infeed slot, then feed it slowly forward until engaged by the rollers.
2750 op#2 R3.doc | Page |
