Crossfolder latches | Xerox 2750 instruction

5.Rotate the drum in either direction to free one end of the document. Grasp and remove the document. Close and lock the clam shell, then close the accordion folder lid.

6.If the document cannot be removed as described above, it may be caught beneath the folding drum. This will require trained assistance. If you are qualified to perform this service, proceed as follows:

Switch off the folder at the power entry panel, then remove the power cord.

Raise the upper section of the crossfolder.

Remove the rear panel of the crossfold section.

Remove the hitch pin from the locating tongue between accordion and crossfold sections.

You are about to enter an area where line voltage (115 or 230Vac) is present unless you have

REMOVED THE POWER CORD.

CROSSFOLDER

Crossfolder latches

The upper section of the crossfolder is locked in place by latches on either side of the chassis. To release the upper section, press gently down on one corner at the rear of the unit, then press the plunger as shown. Release the other latch in the same way.

Gas springs weaken with age. Prop up the upper section of the crossfolder safely by other means if you feel that the gas springs do not support it adequately.

Upper section of the crossfolder in raised position

2750 op#2 R3.doc 10-02

Page 2-13

Image 26

Xerox 2750 manual Crossfolder latches, Upper section of the crossfolder in raised position

Contents

PRINTFOLD Synergix Fold System Engineering Document Folder Main components of the Model 2750 Folder General informationSynergix Fold System Power entry module / counter / communications port Operator’s control panel Main control panel Stacker/Handfeed Instant service accessBridge Automatic document diversion Tower in normal folding and bypass modes Manual feed slot Accordion folding overview Standard accordion fold packet Type F bookfold packet Crossfolding overview Folds handle easier than Z-folds LEL = non-standard feed direction Key facts about fold programsSEL = standard feed direction Width sensors at input end of bridge Main features of the 2750 folding system Options available Model 2750 Folder operator’s side After installationPower entry panel 12 Z-folded packet, portrait style Operator’s controls½ x 11 C-folded packet, landscape style BkaZ ½ x 11 book-folded packet Z fold only Fold Selection Host controller Start-up On-line programs Reset procedureFold Selection Standalone Hand feed programs Manual document feeding Rear of diverter tower, showing stacker/off-line components To begin hand feeding Hand feeding a document Exiting Handfeed Mode Jam conditions Clearing a jam Raising the bridge lid Bridge and Bridge ExitIf the document is visible Unlocking the bridge Raising the bridge Access to the towerTower Accordion folder lid in raised position Use the jog feature …Accordion Folder Opening the upper clam shell Ejector springs on crank handle Using the crank handle to rotate the drumRaising the drum faceplate shutter Upper section of the crossfolder in raised position CrossfolderCrossfolder latches Crossfolder rear panel Crossfold TransferCrossfold Pocket and Crossfold Exit Unhitching the accordion and cross folder Crossfold pocket Interlock OpenCrank handle engaged in crossfold roll System Error In-feed and accordion folding components Initial phase of the folding programAccordion Folder Completion of the first fold Panel measuring phaseDrum reversal develops a loop Starting the second fold Accordion fold compensating panels First crossfold action Document inversionCrossfolder Single crossfold mode Double crossfold mode Operator’s control panel System Menu Jog functions PasswordsCommunications mode Parameter viewing and modification Accessible only to the Key Operator and technician Device test Sheets 1s 3 0 5 Recent errorsActivity counters 721p Synergix Fold System 40 & XES 2750 Series fold tables Description Afnor Fold Banks Peco Fold MIX Fold Bank 1 common European sizes Folder Error Messages Message Definition Location or type of error