Xerox 75 MX manual Performance tables

Paper and other stockOperator Guide

Table 5-1. Staple capability for various paper weights

Weight	Maximum Number of Stapled Sheets
32 lb or 120 gsm	33
65 lb or 244 gsm Cover to	22
110 or 203 gsm Index

When the Top Tray of the Finisher is used: In addition to using the Top Tray as an output location, it is also used for short-edge feed (SEF) sheets less than 6.7 inches (170 mm) long in the feed direction or 8 inches (203 mm) long in the cross-feed direction will go to the Top Tray rather than to the Stacker. It is inherent to the design of the inverter, if the sheet is too short, the output will be sent to the top tray.

During certain jam or error conditions, purged sheets (to be discarded) are also sent to the Top Tray.

Performance tables

In the printer performance tables, various symbols and characters are used to convey information.

Symbols The following symbols in the “Rating” column of a table represent the expected paper handling and image quality performance in typical operating environments.

l = Best performance

o = Good performance

u = Fair - Good performance

x = Not recommended. Exceeds design specifications. Unacceptable performance is likely.

**= Indicates the same performance as shown in Table 5-2.and Table 5-3.for the corresponding paper sizes.

Characters The following characters in the “Note” column of a table provide additional information.

a = Cannot be duplexed.

b = The output will go to the Top Tray and cannot be stapled.

5-4 DocuTech/DocuPrint 75/90 and DocuPrint 75 MX