Operator Guide

Paper and other stock

Tray 6 The High Capacity Tray has a capability of only 8.5 x 11 inch (216 to 279 mm) or A4 long-edge feed (LEF), between 16-32 lb (75-120 gsm).

Trays 1-4Have a capability of 8 to 17 inches (203 to 432 mm); 5.25 to 11 inches (133 to 279 mm). Call the Welcome Center if you want to permanently set any of the Trays 1-4 to process 12 x 18 inch (305 x 457 mm) stock.

General stapling guidelines

To ensure that stapling of thin sets is satisfactory, finishers that are produced after 1998 will cycle down after 30 sets of up to 15 sheets or less. You must empty the stacker in order to resume printing.

If these parameters are not satisfactory for your printing, please contact Xerox.

Dimensions that can be stapled: The minimum size for stapling is 6.7 by 8 inches (170 x 203 mm). The fed edge must be between 8 to 12 inches (203 x 305 mm) to be stapled.

Figure 5-3. Size requirements for stapling

This edge

 

must be

 

between 8 to

 

12 inches (203

Feed

to 305 mm) to

Direction

be stapled.

 

Weights that can be stapled: The Finisher can staple a maximum of 50 sheets of 20 lb paper. The maximum staple capability for other stock weights is shown in Table 5-1.

Table 5-1. Staple capability for various paper weights

Weight

Maximum Number of Stapled Sheets

 

 

20 lb 75 gsm

50

 

 

24 lb or 90 gsm

44

 

 

DocuTech/DocuPrint 75/90 and DocuPrint 75 MX

5-3

Page 61
Image 61
Xerox 75 MX manual General stapling guidelines, Staple capability for various paper weights