Operator Guide

Maintenance

CAUTION

When the power on/standby switch is in stand-by and the AC power cord remains connected to a power receptacle, AC voltage is present in the power supply.

10.If the equipment will be serviced or moved, disconnect the AC power cord from the AC receptacle.

Emergency power-off procedures

An emergency power-off procedure may be used when the power must be switched off immediately.

CAUTION

The controller emergency power off procedure may corrupt the DocuSP software. This method should only be used in an emergency.

Controller Power- To power off the system in an emergency use any of the Off following methods:

Switch off the controller power switch on the front of the controller for an Ultra 30, on the back for an Ultra 10.

On the DocuSP Print Services, the System menu, select the option for Immediate Shutdown.

Pull the controller power cord from its receptacle.

Printer power-offTo power off the printer in an emergency use any of the following methods:

Press the red button on the printer.

Pull the printer power cord from the power receptacle.

An emergency power off of the printer will not corrupt the DocuSP system software. However, you will need to enter Reset at the OK prompt if the controller displays the OK prompt.

Controller or For the printer or the controller, if any of the following conditions Printer Emergency occur, disconnect the power cable from the power socket

Conditions immediately and contact an authorized Xerox Service

Representative to correct the problem

The equipment emits unusual odors, or makes unusual noises.

DocuTech/DocuPrint 75/90 and DocuPrint 75 MX

4-9

Page 51
Image 51
Xerox 75 MX manual Emergency power-off procedures