About Remote Layers 255
DM2000 Version 2—Owner’s Manual
ENCODER: These parameters are used to specify the MIDI message (up to 16 bytes) to be
transmitted when an Encoder is operated. Use the [SEL] buttons to select the channel strips,
and then edit as necessary. When a value from 00 to FF is specified, that value is transmitted
when an Encoder is adjusted. For the ENC setting, the Encoder’s current value from 0–127
is transmitted when it’s adjusted. The END setting specifies the end of the data. “–” means
no data is transmitted.
LEARN: This works the same as the [ON] button Learn function above, except the received
MIDI messages are displayed in the ENCODER DATA area. Only one Learn function can
be used at a time.
FADER: These parameters are used to specify the MIDI message (up to 16 bytes) to be
transmitted when a fader is operated. Use the [SEL] buttons to select the channel strips, and
then edit as necessary. When a value from 00 to FF is specified, that value is transmitted
when a fader is adjusted. For the FAD setting, a fader’s current value from 0–127 is trans-
mitted when it’s adjusted. The END setting specifies the end of the data. “–” means no data
is transmitted.
LEARN: This works the same as the [ON] button Learn function above, except the received
MIDI messages are displayed in the FADER DATA area. Only one Learn function can be
used at a time.

Using User Defined Remote Layers

Once configured, User Defined Remote Layers can be used as follows.
1Use the LAYER REMOTE [1–4] buttons to select the User Defined Remote Lay-
ers.
While a User Defined Remote Layer is selected, operating the channel strip faders, Encod-
ers, and [ON] buttons causes the specified MIDI data to be transmitted.
When a User Defined Remote Layer is selected, the corresponding Remote page appears.
Since this is the same page as that selected by the DISPLAY ACCESS [REMOTE] button,
User Defined Remote Layers can be configured here as well, even the target can be changed.
When a User Defined Remote Layer is selected, the channel strip displays
show Remote channel strip Short names. The border of the currently
selected channel’s channel strip display lights up. The Encoder displays
indicate the positions of the Encoders.
The settings of the channel strip faders, Encoders, and [ON] buttons,
and the current target and bank setting for each Remote Layer are stored
in Scenes. When a Scene is recalled, if the Remote Layer’s target is the same as when the
Scene was stored, the faders, Encoders, and [ON] buttons are set accordingly and the cor-
responding MIDI data is transmitted (so long as the TRANSMIT parameter is set to
ENABLED). If the target is not the same, the faders, Encoders, and [ON] buttons are set
accordingly, but no MIDI data is transmitted.
GM01