Installation
Enjoying surround effects regardless of conditions (My Surround)
The My Surround function creates rich surround sound effects in rooms with less than optimal surround sound conditions (☞p. 11). See “Changing the audio output method for surround playback” (☞p. 36, 37) for more information.
If the TV remote control does not work properly after the center unit is installed (TV Remote Repeater function)
The TV may not respond to commands from its remote control if the center unit obstructs the remote control sensor on the TV. Should
this occur, press the REMOTE |
| TV remote | |
REPEATER key on this unit’s remote |
| ||
TV remote control | control sensor | ||
control more than 3 seconds to set the TV | |||
| |||
|
| ||
Remote Repeater function to enable. The |
|
| |
REPEATER indicator on the front panel |
|
|
display will light. When the TV remote control is aimed at the
center unit’s remote control sensor, the TV Remote Repeater on the back of this unit transmits signals from the TV remote control to the TV.
Signals from the TV remote control can be transmitted to the TV while this unit is in standby mode.
Note
This function can be used while the TV remote control is using infrared signals.
If the center unit cannot be installed on a TV stand (increasing the height of the center unit)
In most cases, the center unit can be placed on a TV stand. The supplied spacers can be attached to increase the height of the unit if necessary. Attach both the left and right spacers to the unit.
Align the protrusions on the back of the spacer with the mounting holes on the bottom of the center unit and press the spacer firmly into place.
Spacer
Removing the spacers
Pull the spacers straight up.
Pull the spacer straight up.
Protrusions
Mounting holes
Bottom of the center unit