Initial settings
S/T
| X |
| ENTER |
SETUP | RETURN |
AUTO SETUP via setup menu
1 Place the IntelliBeam microphone at your normal listening position, and press the
SETUP key.
See “Installing the IntelliBeam microphone” (☞p. 23) for instructions on positioning the IntelliBeam microphone.
2 Press the S/T key to select “BEAM” and then press the X key.1)
3 Press the S/T key to select “IntelliBeam” and then press the X key.1)
4 Press the S/T key to select one of the items below and then press the X key.1)
Select Item:
“BEAM+SOUND OPTIMIZE”
(Beam optimization and sound optimization)
Select this optimization feature if you make settings for the first time. This menu takes about 3 minutes.
“BEAM OPTIMIZE ONLY” (Beam optimization only)
Use to optimize the beam angle so that the parameter best matches your listening environment. This menu takes about 1 minute.
“SOUND OPTIMIZE ONLY” (Sound optimization only)
Use to optimize the beam delay, volume, and quality so that the parameters best match your listening environment. This menu takes about 2 minutes.
You must optimize the beam angle with “BEAM OPTIMIZE ONLY” before starting “SOUND OPTIMIZE ONLY”. Select this optimization feature in the following cases:
•If you have opened or closed the curtains in your listening room before using this unit
•If you have manually set the beam angle.
5 Connect the IntelliBeam microphone to this unit after “AUTO SETUP (PREPARATION & CHECK)” screen is displayed.
For the details on connecting IntelliBeam microphone, refer to “Using AUTO SETUP (IntelliBeam)” (☞p. 24).
6 Follow steps 4, 5, and 6 under “Using AUTO SETUP (IntelliBeam)” to configure settings, and then remove the microphone.
1)y
The ENTER key performs the same function as the X key.