Playback features
Saving energy with the Eco function
When the Eco function is enabled, this unit automatically enters standby mode as follows.
•No operations are performed with this unit for 3 hours2)
•No input signal is received for 30 minutes
•Playback of content stored on the iPod connected to
•The iPod to which
•The iPod to which
•The
•The
Press the ECO key.
“ECO ON” is displayed and the front panel display turns off.
ECO ON
The brightness of STATUS and SURROUND indicators is minimized.
yTips
The following restrictions apply when the Eco function is enabled.
•This unit will not turn on when content stored on the iPod to which
•If this unit is configured to output audio from the TV using the HDMI control function (☞p. 31), this unit will enter standby mode.
Switching information displayed in the front panel display
The input source and surround information is displayed.
Press the INFO key.
Display changes as follows each time the INFO key is pressed. The specific information displayed varies according to the input source.
Input source: HDMI1– 4, YIT, TV, OPTICAL, ANALOG, FM3)
Input: Name of the input source
(When FM is input, an FM station frequency is displayed.)
T
Beam: Beam mode setting (☞p. 36)
T
Decoder: Current decoder (☞p. 38)
T
Cinema DSP: CINEMA DSP program (☞p. 34)
T
See pages 53 and 56 for instructions on switching display when the input source is USB.3)
PREPARATION
PLAYBACK
SETTINGS
Disabling the Eco function
Press the ECO key.
“ECO OFF” is displayed in the front panel display.
TROUBLESHOOTING
2) y | 3) y |
This unit enters standby mode after 12 hours have passed since the last | |
operation was performed, even when the Eco function has been set to |
|
“OFF”. |
|
APPENDIX