Initial settings

The screen below is displayed after connecting IntelliBeam microphone to the unit.1)

AUTO SETUP

(PREPARATION & CHECK)

Please connect the MIC.

Please place the MIC at least 1.8m/6ft away from Sound Pro- jector. The MIC should be set at ear level when seated. Measurement takes about 3min. After [ENTER] is pressed, please leave the room.

[ENTER]:Start [RETURN]:Cancel

5 Press the ENTER key to confirm the results.4)

Measurement results are applied to this unit.

AUTO SETUP COMPLETE

Please remove the MIC from Sound Projector and the listening position.

Press [SYSTEM MEMORY] key to save set-up in the memory.

PREPARATION

Note

• The measurement results are stored in the internal

memory of this unit until you run the AUTO SETUP

Follow the instructions below and then leave the room. If you remain

procedure again or configure the settings manually.

in the room, you may obstruct the beam, or the microphone may pick

• You can save the several measurement results pressing

up any sounds you make, possibly resulting in improper

configuration of settings.

the SYSTEM MEMORY key (☞p. 28).

4

Press the ENTER key to start the AUTO

6

Remove the IntelliBeam microphone.

 

 

 

SETUP procedure and then leave the room

 

 

 

within 10 seconds.2)

 

The “AUTO SETUP COMPLETE” screen closes.

5)

 

 

 

 

 

The screen automatically changes during the AUTO

 

Keep the IntelliBeam microphone in a safe place.

 

 

SETUP procedure.

 

 

 

 

AUTO SETUP START

 

 

 

 

Will begin in 10 sec.

 

 

 

 

Please leave the room

 

 

 

 

----------

 

 

 

 

[RETURN]:Cancel

 

 

 

 

(After 3 min.)

 

 

 

SHOW RESULT

MESUREMENT COMPLETE.

ENVIRONMENT CHECK: Success

BEAM MODE: 5Beam/Plus2

[ENTER]:Save set-up.

[RETURN]:Do not save set-up.

If the AUTO SETUP procedure is complete, this unit rings the chimes.3)

PLAYBACK

SETTINGS

TROUBLESHOOTING

1)y

“BEAM+SOUND OPTIMIZE” is selected automatically. When you perform “BEAM OPTIMIZE ONLY” or “SOUND OPTIMIZE ONLY” only, refer to “AUTO SETUP via setup menu” (☞p. 26).

2)y

•Wait outside the room during the AUTO SETUP procedure. Remaining in the room after the AUTO SETUP process begins may result in the improper configuration of settings as your body may obstruct sound beams or the microphone may pick up sounds you make inadvertently.

•The AUTO SETUP procedure takes about 3 minutes.

•To cancel the AUTO SETUP procedure after it is started, press the

RETURN key.

3)y

If an error occurs, an error buzzer sounds and an error message is displayed. For details on error messages, see “If an error message is displayed” (☞p. 27).

•If “ENVIRONMENT CHECK:Failure” is displayed, accurate measurement may not have been possible. See “ERROR-E1” under “Error messages” (☞p. 27) for the remedy to this most common error. Press the RETURN key and begin measurement again.

•Depending on the environment of your listening room, the front left and right beam angles and left and right surround beam angles may be set to the same value even if “BEAM MODE :5Beam” is displayed as a result.

4)y

If you do not want to apply the results, press RETURN key.

APPENDIX

5)y

When AUTO SETUP is performed from the setup menu, the menu selection screen of the setup menu appears.

25 En