Initial settings

Establishing a wireless connection

Yamaha’s proprietary yAired technology enables the wireless connection of the center unit and subwoofer. Wireless connection

Displaying the menu screen on the

TV

of the subwoofer allows for subwoofer installation without concern for cables. When the transmitter (YIT-W12TX) is used, iPods or computers can be connected wirelessly to play music stored on these devices through this unit.

For details of YIT-W12TX, refer to “Safety and Accessory Information” (separate booklet).

When playing content from a TV or Blu-ray disc player, the center unit transmits audio signals that are received by the subwoofer. When YIT-W12TX is used to play songs stored on an iPod or computer, YIT-W12TX sends audio signals that are received by the center unit and subwoofer.

Visual operation of this unit is possible by displaying its menu screen on the TV.

Use the button for switching between input sources on the TV’s remote control to select this unit.

When this unit and the TV are connected as shown below, select “HDMI 1”.

TV remote control (example)

Switch input sources

The same group ID must be assigned to all components. By default, the center unit, subwoofer, and YIT-W12TX are assigned a group ID of A1. This group ID does not need to be changed.

Group IDs

The center unit, subwoofer, and YIT-W12TX can be assigned a group ID from three possible sets: A1–A3, B1–B3, C1–C3. A1–A3, B1–B3: Audio delay is less than that of the C1–C3 set. C1–C3: Use when playing music stored on a computer via this unit (☞p. 48).

To prevent wireless connection of another yAired Yamaha sound system or device installed near this unit or the YIT-W12TX, assign a different group ID to this unit and the YIT-W12TX.

Changing the group ID

Center unit

Change the group ID from “GROUP ID” in the setup menu (☞p. 64).

Subwoofer

Use the group ID switches on the back of the subwoofer to change the group ID (☞p. 20).

HDMI INPUT

123

TV

this unit

The menu display

The setup menu is displayed on the TV screen when the SETUP key is pressed. When the TV is receiving HDMI signals, the menu is superimposed over video content. Press the SETUP key a second time to cancel setup menu display.

SETUP MENU

PREPARATION

PLAYBACK

SETTINGS

YIT-W12TX

Use the group ID switches on the side of YIT-W12TX to change the group ID. For details of YIT-W12TX, refer to “Safety and Accessory Information” (separate booklet).

BEAM

IntelliBeam

SOUND

HORIZONTAL ANGLE

HDMI

BEAM TRAVEL LENGTH

yAired

FOCAL LENGTH

DISPLAY

IMAGE LOCATION

INFORMATION

CHANNEL OUT

Note

The setup menu (☞p. 58) can only be displayed on a TV screen. It cannot be shown in the front panel display.

TROUBLESHOOTING

APPENDIX

21 En