Select this unit as the input source of the TV.

Initial settings

Setting the HDMI control function

1 Turn on all components connected to this unit via HDMI cable.

2 Enable the HDMI control function of all components connected to this unit via HDMI cable.

For this unit, set “HDMI CONTROL” to “ON” (☞p. 63).2) For external components, refer to the manual supplied with each component.3)

3 Turn off the TV and then turn on it again.

Registering HDMI compatible components to the TV4)

1

2 Turn on an external components, such as a Blu-ray disc player, connected to this unit via HDMI cable.

3 Select the input source of this unit to Blu-ray disc player and check whether the image in the player is correctly displayed or not.

If the Blu-ray disc player is connected via HDMI IN1 jack, press the HDMI1 key.

Input source name

HDMI1

4 Check if the HDMI control function works (turn on this unit or adjust the volume level using the remote control of the TV).

If the HDMI control function is not working

Be sure that all components are correctly connected to this unit, and that settings are properly configured as described below.

–The TV is connected to the HDMI OUT (ARC) jack of this unit.

–“HDMI CONTROL” (☞p. 63) is set to “ON” in the setup menu.

–The HDMI control function is enabled on the TV. (Also check the relative settings such as power interlock function or speaker priority.)

When the HDMI control function is not still working even after the above has been checked,

–Turn off this unit and the TV, and then turn them back on again.

–Disconnect the AC power supply cable of the unit and external components connected to the unit via HDMI cable. Plug them in again after about 30 seconds.

–After OPTICAL, ANALOG, AUX, YIT, or USB5) input has been enabled, switch the input source for the TV and this unit to the components connected via HDMI cable.

Changing the connection method and connected components

When the connected components and jacks are changed, reset this unit with the following procedure.

1 Disable the HDMI control function of the TV and Blu-ray disc player, turn off all connected components, and change the connections.

2 Perform steps 1 to 3 of “Setting the HDMI control function”.

PREPARATION

PLAYBACK

SETTINGS

TROUBLESHOOTING

2)

y

4) y

• The default setting is “OFF”.

For some HDMI compatible components, registering HDMI compatible

• When “HDMI CONTROL” is set to “ON”

components to TV is not required in this case when the HDMI control

 

When the Eco function (☞p. 41) is enabled, this unit enters standby

function is enabled.

 

mode if the TV is selected for audio output using the TV’s remote

5) y

 

control.

3)

y

YSP-4300 only

 

The example of TV settings

•From the setup menu on your TV, select “Link setting”  “HDMI control setting”, then set a setting such as “HDMI control function” to “ON”.

•Setting such as “Speaker priority” should be set to “AV amplifier”.

APPENDIX

31 En