Installation 25
External PSII
Figure 2 • Parallel Port
1
1Parallel connector
3.Secure the wire locks.
4.On the back of the PSII, insert a live
5.Turn on the printer.
A red status indicator blinks during the Power On Self Test (POST) and changes to green when the initialization is finished.
The Test button is a small hole on the PSII device. To press it, you need to insert something small into the hole, like a paperclip.
6.Press the Test button located on the bottom of the PSII. This prints out a PSII configuration label.
Important • Label length, DPI and your firmware version:
•For all printers, the minimum label length is 4 in. (10.16 cm).
•For printers with firmware version 7.01 and higher, regardless of the dpi, a
•For printers with firmware version 7 and lower, see the table that follows.
This table shows you how to determine the minimum label width needed to print a PSII configuration label for printers with firmware version 7 or lower:
DPI | Inches |
|
|
600 | 1.25 |
|
|
300 | 2.50 |
|
|
200 | 3.69 |
|
|
150 | 5.0 |
|
|
04/21/2009 | ZebraNet PrintServer II User Guide |