32Installation Internal PSII
To install an internal PSII into a Z4Mplus printer, complete these steps:
Tools • You need these tools to complete this procedure:
| 7 mm Nutdriver |
1.Caution • Observe proper electrostatic safety precautions when handling
Connect yourself to an antistatic device.
2.Caution • Turn off (O) the printer and disconnect it from the power source before performing the following procedure.
Turn off (O) the printer and disconnect the AC power cord and all data cables.
3.See Figure 8. Lift the media door and locate the screw in the middle of the hinge along the top of the printer frame.
4.Remove the screw and the lock washer.
Figure 8 • Z4Mplus Media Door and Compartment
| 1 |
4 | 2 |
3
1 Media door
2 Lock washer
3 Screw
4 Electronics cover
5.Close the media door.
ZebraNet PrintServer II User Guide | 04/21/2009 |