28Installation Internal PSII

Caution • A qualified service technician must perform this installation.

To install an internal PSII into a XiII, XiIII, R140, 105SL, and PAX Series printer, complete these steps:

Tools • You need these tools to complete this procedure:

‰ Phillips Screwdriver Set

‰ 3/32 in. Allen Wrench

1.Caution • Observe proper electrostatic safety precautions when handling static-sensitive components such as circuit boards and printheads.

Connect yourself to an antistatic device.

2.Caution • Turn off (O) the printer and disconnect it from the power source before performing the following procedure.

Turn off (O) the printer and disconnect the AC power cord and all data cables.

3.From the back of the printer, remove the two screws and the blank cover plate positioned next to the main RS-232 and parallel interface connectors.

4.Which printer model do you have?

If you have

Then…

a(n)…

 

 

 

 

 

XiII, XiIII series,

a.

See Figure 5.

R140, or a 105SL

b. To remove the side panel, remove the screws and remove the

 

 

left side panel.

PAX

a.

See Figure 6.

 

b. To remove the side panel, access the electronics by removing

 

 

the mounting screws from the printer’s PCB access panel and

 

 

sliding the panel out.

45537L-005

ZebraNet PrintServer II User Guide

04/21/2009