36Installation Internal PSII
13.See Figure 12. Place the I/O board inside the plate, and plug the cable into the connector on the I/O board.
Figure 12 • Z4Mplus I/O Board and Plate
3
2
1
1Plate
2I/O Board
3I/O Board connector
.
Note • The parallel port on the back of the printer cannot be used when the internal PSII is installed. The hardware of the PSII mounting bracket covers the parallel port.
14.Using the screws removed in step 7, screw the plate onto the back of the printer.
15.Reinstall the electronics cover.
16.
Caution • Reconnect the printer to the power source and turn on (l).
Reconnect the AC power cord and all data cables and turn on (l) the printer.
If the green status indicator is solid (not blinking), the PSII has power.
17.Consult your System Administrator before configuring the PSII for your network. To establish the network connection, refer to the section applicable to your network type.
ZebraNet PrintServer II User Guide | 04/21/2009 |