46Getting Started Assigning an IP Address
Assigning an IP Address
Before you can begin working with PSII, you must get or assign an IP address for the PSII device.
Important • Throughout the procedure in this chapter, there are some features that require the default User ID and/or default password. If you are prompted, these are the defaults:
•User ID: admin
•Password: 1234
With Dynamic Host Configuration Protocol (DHCP)
If your network uses DHCP, your PSII device is assigned a temporary IP address. This is important to know, because you have the option to make the temporary IP address the permanent IP address.
Note • Check with your Network Administrator to see whether your network uses DHCP.
Without DHCP
If your network does not use a dynamic IP addressing system (such as DHCP), you need to set a permanent IP address of the PSII device.
ZebraNet View
ZebraNet View is the
Important • The remaining sections are dependent on the successful installation of ZebraNet Utilities, which you should have completed on page 37.
ZebraNet PrintServer II User Guide | 04/21/2009 |