30Installation Internal PSII
Note • The parallel port on the back of the printer is not operational when the internal PSII is installed. The hardware of the PSII mounting bracket covers the parallel port.
5.Insert the ribbon cable and PSII through the mounting slot.
6.Fold the cable and the ferrite bead back over the mounting bracket, and connect the ribbon cable connector into the keyed Interface Data Cable Connector (J4) on the main logic board.
7.Secure the PSII interface board in place with the cover plate screws that you removed in step 3 of this procedure.
8.Confirm that all small cable connectors are tight.
9.Which printer model do you have?
If you have | Then… | |
a(n)… | ||
| ||
|
| |
XiII, XiIII series, | a. See Figure 5. | |
R140, or a 105SL | b. Reinstall the | |
| c. Replace the screws that you removed in step 3 of this | |
| procedure. | |
|
| |
PAX | a. See Figure 6. |
b.Reinstall the PCB access panel and gently slide the panel into the back of the print engine.
c.Replace the screws that you removed in step 3 of this procedure.
10.This kit includes a label printed with the Ethernet MAC hardware address for the PSII. Remove the backing from the label and affix it to the back of the printer.
11.
Caution • Reconnect the printer to the power source and turn on (l).
Reconnect the AC power cord and all data cables and turn on (l) the printer.
12.Consult your System Administrator before configuring the PSII for your network! To establish the network connection, refer to the section applicable to your network type.
ZebraNet PrintServer II User Guide | 04/21/2009 |