Installation 35
Internal PSII
9.See Figure 11. Insert the short ends of each standoff into the holes on the main logic board until you hear a click.
Figure 11 • Z4Mplus Main Logic Board and Standoffs
1
2
1Parallel port connector on the main logic board
2Standoffs (3)
10.See Figure 10 and Figure 11. From the electronics enclosure, plug the parallel port socket of the PSII board into the parallel port connector on the main logic board.
11.Align the holes in the PSII board with the standoffs and snap into place. Be sure the PSII is seated securely.
12.Does your printer have a PCMCIA card installed?
If… Then…
No a. With the PSII board connected to the main logic board, feed the connector through the mounting slot in the back of the printer.
b.Continue with step 13.
Yes a. With the PSII board connected to the main logic board, feed the connector over the PCMCIA card, then through the mounting slot in the back of the printer.
b.Continue with step 13.
04/21/2009 | ZebraNet PrintServer II User Guide |