Configuring the Software of Printer Driver
Many printer settings may also be controlled by your printer’s driver or label preparation software. Refer to the driver or software documentation for more information.
Printing a Test Label
To print a test label:
1.Turn off the printer.
2.Press and hold the CANCEL key while turning on the printer.
3.Release the key after the DATA light turns off (approximately five seconds).
A configuration label, which shows the printer’s currently stored parameters, will print (similar to the one shown in Figure 10).
If you encounter any problems while you are configuring the printer or printing a test label, refer to Troubleshooting, which starts on page 67. Otherwise, refer to Establishing Communication on page 17 to set up the communication parameters.
Figure 10
PAGE 10 OF 57 | 0808 |