Warning CUTTER JAM
Problem | Solution |
| Turn off the printer power and unplug the printer. |
Cutter blade is in the media path. | Inspect the cutter module for debris and clean as |
| needed following the cleaning instructions on page 60. |
|
|
OUT OF MEMORY*
Problem | Solution | |
| Insufficient DRAM for the label length, downloaded | |
| fonts/graphics, and images. | |
*There is not enough memory to perform |
| |
Ensure that the device, such as FLASH memory or | ||
the function shown on the second line of | ||
PCMCIA card, is installed and not write protected or full. | ||
the error message. | ||
| ||
Ensure that the data is not directed to a device that is | ||
| ||
| not installed or available. | |
|
|
Print Quality Problems
General print quality issues
Problem | Solution | |
You are using an incorrect media and | Consult your authorized Zebra reseller/distributor for | |
ribbon combination for your application. | information and advice. | |
|
| |
The printer is set at the incorrect print | For optimal print quality, set the print speed to the | |
lowest possible setting via ZPL II, the driver, or the | ||
speed. | ||
software. | ||
| ||
|
| |
The printer is set at the incorrect darkness | For optimal print quality, set the darkness to the lowest | |
possible setting via the front panel, the driver, or the | ||
level. | ||
software. | ||
| ||
|
| |
The printhead is dirty. | Clean the printhead according to the instructions on | |
page 56. | ||
| ||
|
| |
There is light printing (or no printing) on | The pressure adjustment dials need to be adjusted. | |
the left or right side of the label or the | Follow the printhead pressure adjustment instructions | |
printed image is not sharp. | on page 62. | |
|
|
PAGE 54 OF 57 | 0808 |