Zebra Technologies H-974 manual 30

Display Shows	Action/Explanation
	Selecting Print Mode Press the INCREMENT (+) or DECREMENT (-) key to
	display other choices.
	Default: Tear-off
PRINT MODE	Selections: Tear-off, peel-off, cutter, rewind
	Print mode settings tell the printer the method of media delivery that you wish
	to use. Be sure to select a print mode that your hardware configuration
	supports since some selections displayed are for optional printer features.
	Setting Media Type Press the INCREMENT (+) or DECREMENT (-) key to
	display other choices.
	Default: Continuous
	Selections: Continuous, non-continuous
MEDIA TYPE	This parameter tells the printer the type of media you are using. Selecting
	continuous media requires that you include a label length instruction in your
	label format (^LLxxxx if you are using ZPL or ZPL II).
	When non-continuous media is selected, the printer feeds media to calculate
	label length (the distance between two detections of the inter-label gap,
	webbing, or alignment notch or hole).
	Setting the Sensor Type Press the INCREMENT (+) or DECREMENT (-) key to
	display other choices.
	Default: Web
	Selections: Web, mark
SENSOR TYPE	This parameter tells the printer whether you are using media with a web
	(gap/space between labels, notch, or hole) to indicate the separation between
	labels or if you are using media with a black mark printed on the back. If your
	media does not have black marks on the back, leave your printer at the default
	setting (web).
	Setting the Sensor Select Press the INCREMENT (+) or DECREMENT (-) key
	to display other choices.
	Default: Auto select
	Selections: Auto select, reflective, transmissive
SENSOR SELECT	This parameter tells the printer the sensor you wish to use. “Auto select” is
	compatible with most types of media. However, if you encounter difficulties
	with calibration, refer to “Types of Media” on page 6 to help you choose the
	appropriate sensor for your media. (Select the reflective sensor with either
	continuous or non-continuous black mark media: choose the transmissive
	sensor if you are using non-continuous web media.)
	Selecting Print Method Press the INCREMENT (+) key for the next value;
	press the DECREMENT (-) key for the previous value.
	Default: Thermal transfer
	Selections: Thermal transfer, direct thermal
PRINT METHOD	The print method parameter tells the printer the method of printing you wish
	to use: direct thermal (no ribbon) or thermal transfer (using thermal transfer
	media and ribbon).
	NOTE: Selecting direct thermal when using thermal transfer media and
	ribbon creates a warning condition, but printing will continue.
	Setting Print Width Press the INCREMENT (+) key to increase the value,
	press the DECREMENT (-) key to decrease the value. To change the unit of
	measurement, press the DECREMENT (-) key until the unit of measurement is
	active, then press the INCREMENT (+) key to toggle to a different unit of
PRINT WIDTH	measure (inches, mm, or dots).
	Default:, Range: The default and range of acceptable values may vary
	depending on what printer you have. Refer to “Printing Specifications” on
	page 80 for further information about the ranges available for your model.
	Print width determines the printable area across the width of the label.

H-974

PAGE 30 OF 57 0808 IH-974