Roll Media Loading
Tear-Off Mode
Refer to Figure 14.
1.Press the printhead open lever. The printhead assembly springs up.
2.Flip down the media supply guide.
3.Slide out the media guide as far from the printer frame as possible.
4.Place the roll of media on the media supply hanger.
5.Flip up the media supply guide. Slide in the media supply guide so that it just touches, but does not restrict, the edge of the roll.
6.Feed the media under the dancer, through the slot in the transmissive sensor, under the ribbon sensor, and out the front of the printer.
7.Ensure that the media is against the back of the transmissive sensor. Slide in the media guide so that it just touches, but does not restrict, the edge of the media.
8.Close the printhead assembly.
Media supply guide
Transmissive
sensor
Printhead assembly
|
| Dancer | Media |
Ribbon |
|
| |
Media guide |
| supply | |
sensor |
| ||
| hanger | ||
|
| ||
|
|
| |
Printhead open lever |
|
| |
Figure 14
PAGE 16 OF 57 | 0808 |