Configuration

After you have installed the media and ribbon and the power-on self test (POST) is complete, the front panel display will show “PRINTER READY.” (If the printer fails its POST, refer to page 73.) You may now set printer parameters for your application using the front panel display and the four keys directly below it.

NOTE: Printers that are operating on an IP network can be quickly configured via ZebraNet WebView™ (optional ZebraNet PrintServer II required). For information, refer to ZebraNet Networking: PrintServer II Installation and User’s Guide.

NOTE: Unless otherwise noted, all parameters are listed in the order they are displayed, starting with “DARKNESS.”

Entering the Setup Mode

To enter the programming mode, press the SETUP/EXIT key.

�Press the INCREMENT (+) or DECREMENT (-) key to scroll to the setting you wish to change.

�Press the SELECT key to toggle the functionality of the INCREMENT (+) and DECREMENT (-) keys.

�Press the INCREMENT (+) or DECREMENT (-) keys to increase or decrease the value; answer “yes” or “no”; print a label; or, select the digit you wish to change.

�Press the SELECT key again to use the INCREMENT (+) and DECREMENT (-) keys to scroll to the desired menu item.

An asterisk (*) in the upper left-hand corner of the display indicates that the value displayed is different than the currently stored value.

H-974

PAGE 27 OF 57

0808 IH-974