Cleaning the Power Peel-Off Module

(Power peel-off option required)

Perform the following procedure if adhesive buildup begins to affect peel performance.

Refer to Figure 24.

1.Open the printhead assembly.

2.Open the front housing assembly by lifting the two handles; then, pivot down the front housing assembly.

3.Remove the accumulated adhesive by rolling the sticky side of a blank label against the peel rollers and lifting it away. (Do this step repeatedly until a majority of the adhesive is gone.)

4.Use a swab soaked with the Zebra-recommended solvent to remove adhesive from the tear-off/peel-off bar and reflective surface.

5.Close the front housing assembly.

6.Close the printhead assembly.

Printhead assembly

Tear-off/ peel-off bar

Peel

rollers

Reflective

surface

Front

housing

assembly

Handles

Figure 24

H-974

PAGE 44 OF 57

0808 IH-974