(Value peel option required)
Refer to Figure 16.
1.Press the printhead open lever. The printhead assembly springs up.
2.Flip down the media supply guide.
3.Slide out the media guide as far from the printer frame as possible.
4.Place the roll of media on the media supply hanger.
5.Flip up the media supply guide. Slide in the media supply guide so that it just touches, but does not restrict, the edge of the roll.
6.Feed the media under the dancer, through the slot in the transmissive sensor, and under the ribbon sensor.
7.Pull approximately 12” (305 mm) of media through the front of the printer.
8.Ensure that the media is against the transmissive sensor. Then, slide in the media guide so that it just touches, but does not restrict, the edge of the roll.
9.Pull down the lever to open the pivot bracket assembly.
10.Feed the media over the
11.Close the printhead assembly.
12.Close the pivot bracket assembly.
13.Peeling will automatically start. Press the FEED key to test.
Media supply guide
Transmissive
sensor
Printhead
Lever assembly
|
| Dancer | Media |
|
|
| |
Label | Ribbon Media guide |
| supply |
| sensor |
| hanger |
| Printhead open lever |
|
|
Figure 16
PAGE 18 OF 57 | 0808 |