Configuring the Printer

The configuration procedure in the next table contains the information you need to get your printer up and running, but it is not comprehensive. Refer to page 40 for more information.

�Press the SETUP/EXIT key at the “PRINTER READY” display to enter the configuration mode.

NOTE: You will need to press the INCREMENT (+) key more than once to advance to some of the displays.

�Press the INCREMENT (+) or DECREMENT (-) key to scroll to the setting you wish to change.

�Press the SELECT key to toggle the functionality of the INCREMENT (+) and DECREMENT (-) keys.

�Press the INCREMENT (+) or DECREMENT (-) keys to increase or decrease the value; answer “yes” or “no”; print a label; or, select the digit you wish to change.

�Press the SELECT key again to use the INCREMENT (+) and DECREMENT (-) keys to scroll to the desired menu item.

Parameter

Selections/Explanation

PRINTER READY

You are ready to configure the printer.

 

 

DARKNESS

0 to 30 (default setting is “10”)

 

 

PRINT MODE

Tear-off, peel-off, cutter, rewind (default is “tear-off”)

 

 

MEDIA TYPE

Non-continuous, continuous (default setting is “non-continuous”)

SENSOR TYPE

Web, mark (default setting is “web”)

PRINT METHOD

Thermal transfer, direct thermal (default setting is “thermal transfer”)

 

 

�After you have configured the print method, press the SETUP/EXIT key to save the changes and exit the configuration mode.

H-974

PAGE 9 OF 57

0808 IH-974