Zoom X4 manual PWR light on the unit’s front panel turns on

(For reference, we have included a table that defines these back panel ports, or jacks; see page 39.)

	a	Plug one end of the included power adapter into the
		unit’s PWR jack and the other end into a power strip or
		wall receptacle.
	b	Turn the unit on by pushing the ON/OFF toggle switch.
		The PWR light on the unit’s front panel turns on.
	c	Plug one end of the supplied phone cord into the unit’s
		ADSL jack and the other end into the ADSL wall jack.
	d	Plug one end of the straight-through Ethernet (10BaseT)
		cable into the modem’s ETHERNET jack and plug the
		other end into your computer’s corresponding Ethernet
		port.
	Note: You can also attach the X4 to an access point or a
	network hub via its ETHERNET jack and thereby connect
	multiple computers.
	—If your hub has an uplink or daisy chain port, you can use
	the supplied straight-through Ethernet cable to connect the
	two.
	—If your hub has a numbered port or if you are using an
	access point, you need a crossover Ethernet cable (sold
	separately).
	Throughout this manual, when we refer to an X4 Ethernet
	connection, it should be understood that this connection may
	be to a computer, access point, or hub.
3 Turn your computer back on.
4	The unit performs a startup sequence—the front panel LINK
	light blinks. (For reference, we have included a table on page

39 that defines the X4’s front panel lights.) When the LINK light changes from blinking to solid, proceed to Establishing Communication with the X4 (page 10).

8 X4 ADSL Modem User’s Manual