ZyXEL Communications 100IH manual Ethernet Setup, Loopback test

Prestige 100 and 100IH ISDN Router and Router/Hub

When you are finished, press ENTER at the message: ‘Press ENTER to confirm’, the Prestige uses the information that you entered to initialize the ISDN line. It should be noted that whenever the switch type is changed, the ISDN initialization takes slightly longer.

At this point, the Prestige asks if you wish to test your ISDN. If you select Yes, the Prestige will perform a loop-back test to check the ISDN line. If the loop-back test fails, please note the error message that you receive and take the appropriate troubleshooting action.

Setup LoopBack Test...

Dialing to 40000// ...

Sending and Receiving Data ...

Disconnecting...

Figure 2-15 Loopback test

2.9Ethernet Setup

This section describes how to configure the Ethernet using Menu 3 – Ethernet Setup. From the Main Menu, enter 3 to open Menu 3.

Menu 3 - Ethernet Setup

1.General Setup

2.TCP/IP and DHCP Setup

Enter Menu Selection Number:

Figure 2-16 Menu 3 - Ethernet Setup

2-20 Hardware Installation and Setup