Prestige 100 and 100IH ISDN Router and Router/Hub
Chapter 2 Hardware Installation & Initial Setup
2.1.1 Front Panel LEDS OF P100
The LED indicators on the front panel indicate the operational status of the Prestige 100. The following table describes the LED functions:
| ISDN | ETHERNET | PHONE |
| PWR TST LNK B1 B2 LNK TX | RX COL | 1 2 |
ISDN Router |
|
|
|
| Figure |
|
|
| Table |
|
|
PWR | The PWR (power) LED is on when power is applied to the Prestige. | ||
TST | A blinking TST (test) LED indicates the Prestige is functioning properly. A | ||
| steady or an off TST indicates malfunction. |
|
|
ISDN: LNK | The LNK (Link) LED is on when the Prestige is connected to an ISDN | ||
| switch and the line has been successfully initialized. |
| |
ISDN: B1/B2 | The B1/B2 LED is on when the corresponding B channel is in use. | ||
ETHERNET |
|
|
|
LNK | The LED is on when the Prestige 100 is connected successfully to Ethernet. | ||
TX/RX | The TX (Transmit)/RX (Receive) LED blinks when data is sent/received | ||
| respectively, through the Ethernet port. |
|
|
COL | The LED is on when a collision is detected. |
|
|
|
|
| |
PHONE: 1/2 | The LED is on when the device on the corresponding phone port is in use. | ||
Hardware Installation and Setup |
