ZyWALL 5/35/70 Series User’s Guide

47.3.8 GUI-based TFTP Clients

The following table describes some of the fields that you may see in GUI-based TFTP clients.

Table 232 General Commands for GUI-based TFTP Clients

COMMAND

DESCRIPTION

 

 

Host

Enter the IP address of the ZyWALL. 192.168.1.1 is the ZyWALL’s default IP

 

address when shipped.

Send/Fetch

Use “Send” to upload the file to the ZyWALL and “Fetch” to back up the file on your

 

computer.

Local File

Enter the path and name of the firmware file (*.bin extension) or configuration file

 

(*.rom extension) on your computer.

Remote File

This is the filename on the ZyWALL. The filename for the firmware is “ras” and for

 

the configuration file, is “rom-0”.

Binary

Transfer the file in binary mode.

 

 

Abort

Stop transfer of the file.

 

 

Refer to Section 47.3.5 on page 615 to read about configurations that disallow TFTP and FTP over WAN.

47.3.9 Backup Via Console Port

Back up configuration via console port by following the HyperTerminal procedure shown next. Procedures using other serial communications programs should be similar.

1Display menu 24.5 and enter “y” at the following screen.

Figure 368 System Maintenance: Backup Configuration

Ready to backup Configuration via Xmodem.

Do you want to continue (y/n):

2The following screen indicates that the Xmodem download has started.

Figure 369 System Maintenance: Starting Xmodem Download Screen

You can enter ctrl-x to terminate operation any time.

Starting XMODEM download...

3Run the HyperTerminal program by clicking Transfer, then Receive File as shown in the following screen.

617

Chapter 47 Firmware and Configuration File Maintenance