Chapter 2 Hardware Installation and Connections
2.3.3 Installing a Splitter Chassis Card
The splitter card’s type and slot must match those of the line card to which it is to connect. For example, install ASC1024 cards in the slots below an ALC line card in the main chassis (see Figure 34 on page 42). Use the SEC1024 extension card with the VOP1248G VoIP line card. Leave the slot covers on unused splitter slots.
Use the following procedure to install a splitter or extension card in the splitter chassis.
1If there is one splitter chassis below the main IES main chassis, install a line card’s splitter or extension cards below the line card and in adjacent slots (a management switch card does not need a splitter chassis card).
If there are two splitter chassis below the main IES main chassis, install the splitter or extension cards in the splitter chassis slots that correspond to the slot number of the line card in the main chassis.
2Grasp the center of the front panel of the card with one hand and place the other hand under the card to support it.
3Insert the card into the slot and push it in until the front panel of the card is flush with the front panel of the splitter chassis.
4Tighten the two thumbscrews.
Figure 24 Installing a Splitter Chassis Card
| 31 |
|
|