Chapter 2 Hardware Installation and Connections

1Connect the Telco-50 connector end of the cable you want to use for voice service to the Telco-50 connector labeled USER on the splitter chassis rear panel.

2Connect the wiring on the other side of the Telco-50 cable to the upper ports of the MDF using a punch-down tool.

3Connect the telephone wiring from the end-user’s POTS telephone equipment to the lower ports of the MDF.

2.6.5.2 VoIP Installation Scenario B

In this installation scenario, you use a VoIP line card and an SEC1024 extension card in conjunction with a DSL line card, its associated splitter card and an MDF to provide voice service over the Internet and DSL Internet access to certain subscribers (a DSL line card port is reserved for each user even if the user does not subscribe to DSL). See Section 2.6.3 on page 48 and Section 2.5.3 on page 45 for more information on using the VOP1248G in conjunction with DSL line cards. This installation scenario does not apply to G.SHDSL connections.

Figure 46 VoIP Connection Scenario B

56

 

IES-5106M / IES-5112M / IES-6000M User’s Guide