Chapter 2 Hardware Installation and Connections

Figure 44 Installation Scenario C

Use the following procedure for this MDF installation scenario.

1Connect the Telco-50 connector end of the cable you want for DSL service to the Telco-50 connector labeled USER on the splitter chassis rear panel.

2Connect the wiring on the other side of the Telco-50 cable to the upper ports of MDF 3 using a punch-down tool.

3Connect the lower ports of MDF 3 to the upper ports of MDF 2 for those users that want DSL service. (Users who want telephone service only, retain the original connection from the top port of MDF 2 to the bottom port of MDF 1.)

4Connect the telephone wiring from the end-user’s DSL equipment to the lower ports of MDF 2.

5Connect the Telco-50 connector end of the cable you want for phone service to the Telco-50 connector labeled CO on the splitter chassis rear panel.

6Connect the wiring on the other side of the Telco-50 cable to the lower ports of MDF 4 using a punch-down tool.

54

 

IES-5106M / IES-5112M / IES-6000M User’s Guide