Chapter 20 Classifier

Table 47

Advanced Application > Classifier (continued)

LABEL

 

DESCRIPTION

Port

 

Type the port number to which the rule should be applied. You may choose one port only or all

 

 

ports (Any).

 

 

Destination

 

 

 

MAC

 

Select Any to apply the rule to all MAC addresses.

Address

 

To specify a destination, select the second choice and type a MAC address in valid MAC address

 

 

 

 

format (six hexadecimal character pairs).

 

 

 

Layer 3

 

 

Specify the fields below to configure a layer-3 classifier.

 

 

 

DSCP

 

Select Any to classify traffic from any DSCP or select the second option and specify a DSCP

 

 

(DiffServ Code Point) number between 0 and 63 in the field provided.

 

 

 

IP

 

Select an IP protocol type or select Other and enter the protocol number in decimal value. Refer

Protocol

 

to Table 50 on page 169 for more information.

 

 

You may select Establish Only for TCP protocol type. This means that the Switch will pick out

 

 

the packets that are sent to establish TCP connections.

 

 

 

Source

 

 

 

 

 

IP

 

Enter a source IP address in dotted decimal notation.
Address/

 

Specify the address prefix by entering the number of ones in the subnet mask.

Address

 

 

 

Prefix

 

 

 

 

 

Socket

 

Note: You must select either UDP or TCP in the IP Protocol field before you configure the socket

Number

 

 

numbers.

 

 

 

 

Select Any to apply the rule to all TCP/UDP protocol port numbers or select the second option

 

 

and enter a TCP/UDP protocol port number.

 

 

Destination

 

 

 

IP

 

Enter a destination IP address in dotted decimal notation.

Address/

 

Specify the address prefix by entering the number of ones in the subnet mask.

Address

 

 

 

Prefix

 

 

 

 

 

Socket

 

Note: You must select either UDP or TCP in the IP Protocol field before you configure the socket

Number

 

 

numbers.

 

 

 

 

Select Any to apply the rule to all TCP/UDP protocol port numbers or select the second option

 

 

and enter a TCP/UDP protocol port number.

 

 

 

Add

 

Click Add to insert the entry in the summary table below and save your changes to the Switch’s

 

 

run-time memory. The Switch loses these changes if it is turned off or loses power, so use the

 

 

Save link on the top navigation panel to save your changes to the non-volatile memory when you

 

 

are done configuring.

 

 

 

Cancel

 

Click Cancel to begin configuring this screen afresh.

 

 

 

Clear

 

Click Clear to set the above fields back to the factory defaults.

 

 

 

20.3 Viewing and Editing Classifier Configuration

To view a summary of the classifier configuration, scroll down to the summary table at the bottom of the Classifier screen. To change the settings of a rule, click a number in the Index field.

168

 

MES3500-24/24F User’s Guide