ZyXEL Communications MES3500-24, MES3500-24F 38.3.5 Configuring SNMP Trap Group, Port, Type, Table, LABEL, Apply, Click, LABEL, Cancel, Cancel, screen), Options, Username, DESCRIPTION, DESCRIPTION

		Chapter 38 Access Control
Table 125	Management > Access Control > SNMP (continued)
LABEL		DESCRIPTION
IP		Enter the IP addresses of up to four managers to send your SNMP traps to.
Port		Enter the port number upon which the manager listens for SNMP traps.
Username		Enter the username to be sent to the SNMP manager along with the SNMP v3 trap.
		Note: This username must match an existing account on the Switch (configured in the
		Management > Access Control > SNMP > User screen).
Apply		Click Apply to save your changes to the Switch’s run-time memory. The Switch loses
		these changes if it is turned off or loses power, so use the Save link on the top navigation
		panel to save your changes to the non-volatile memory when you are done configuring.
Cancel		Click Cancel to begin configuring this screen afresh.

38.3.5 Configuring SNMP Trap Group

Click Management > Access Control > SNMP > Trap Group to view the screen as shown. Use the Trap Group screen to specify the types of SNMP traps that should be sent to each SNMP manager.

Figure 175 Management > Access Control > SNMP > Trap Group

The following table describes the labels in this screen.

Table 126 Management > Access Control > SNMP > Trap Group

LABEL	DESCRIPTION
Trap Destination	Select one of your configured trap destination IP addresses. These are the IP addresses of
IP	the SNMP managers. You must first configure a trap destination IP address in the SNMP
	Setting screen.
	Use the rest of the screen to select which traps the Switch sends to that SNMP manager.
Type	Select the categories of SNMP traps that the Switch is to send to the SNMP manager.
Options	Select the individual SNMP traps that the Switch is to send to the SNMP station. See
	Section 38.3.3 on page 292 for individual trap descriptions.
	The traps are grouped by category. Selecting a category automatically selects all of the
	category’s traps. Clear the check boxes for individual traps that you do not want the Switch
	to send to the SNMP station. Clearing a category’s check box automatically clears all of the
	category’s trap check boxes (the Switch only sends traps from selected categories).

	297
MES3500-24/24F User’s Guide