ZyXEL Communications MES3500-24, MES3500-24F 38.3.4 Configuring SNMP, lower, lower, lower, Version, Version, both (v3v2c), SNMP manager, Get Community, Set Community, Trap Community, Trap Community

Chapter 38 Access Control

38.3.4 Configuring SNMP

Click Management > Access Control > SNMP to view the screen as shown. Use this screen to configure your SNMP settings.

Figure 174 Management > Access Control > SNMP

The following table describes the labels in this screen.

Table 125 Management > Access Control > SNMP

LABEL	DESCRIPTION
General Setting	Use this section to specify the SNMP version and community (password) values.
Version	Select the SNMP version for the Switch. The SNMP version on the Switch must match the
	version on the SNMP manager. Choose SNMP version 2c (v2c), SNMP version 3 (v3) or
	both (v3v2c).
	Note: SNMP version 2c is backwards compatible with SNMP version 1.
Get Community	Enter the Get Community string, which is the password for the incoming Get- and
	GetNext- requests from the management station.
	The Get Community string is only used by SNMP managers using SNMP version 2c or
	lower.
Set Community	Enter the Set Community, which is the password for incoming Set- requests from the
	management station.
	The Set Community string is only used by SNMP managers using SNMP version 2c or
	lower.
Trap Community	Enter the Trap Community string, which is the password sent with each trap to the
	SNMP manager.
	The Trap Community string is only used by SNMP managers using SNMP version 2c or
	lower.
Trap Destination	Use this section to configure where to send SNMP traps from the Switch.
Version	Specify the version of the SNMP trap messages.

296
	MES3500-24/24F User’s Guide