ZyXEL Communications MES3500-24, MES3500-24F Port, Name, Link, LACP, LABEL, State, screen, TxPkts, RxPkts, Errors, Tx KB/s, Rx KB/s, Up Time, DESCRIPTION, has been up, displays STOP, Clear Counter

Chapter 7 System Status and Port Statistics

The following table describes the labels in this screen.Table 7 Status

LABEL	DESCRIPTION
Port	This identifies the Ethernet port. Click a port number to display the Port Details
	screen (refer to Figure 27 on page 83).
Name	This is the name you assigned to this port in the Basic Setting > Port Setup
	screen.
Link	This field displays the speed (either 10M for 10Mbps, 100M for 100Mbps or
	1000M for 1000Mbps) and the duplex (F for full duplex or H for half). It also
	shows the cable type (Copper or Fiber) for the combo ports.
	This field displays Down if the port is not connected to any device.
State	If STP (Spanning Tree Protocol) is enabled, this field displays the STP state of the
	port (see Section 13.1 on page 122 for more information).
	If STP is disabled, this field displays FORWARDING if the link is up, otherwise, it
	displays STOP.
LACP	This fields displays whether LACP (Link Aggregation Control Protocol) has been
	enabled on the port.
TxPkts	This field shows the number of transmitted frames on this port.
RxPkts	This field shows the number of received frames on this port.
Errors	This field shows the number of received errors on this port.
Tx KB/s	This field shows the number of kilobytes per second transmitted on this port.
Rx KB/s	This field shows the number of kilobytes per second received on this port.
Up Time	This field shows the total amount of time in hours, minutes and seconds the port
	has been up.
Clear Counter	Enter a port number and then click Clear Counter to erase the recorded statistical
	information for that port, or select Any to clear statistics for all ports.

82
	MES3500-24/24F User’s Guide