Chapter 38 Access Control

You can specify a group of one or more “trusted computers” from which an administrator may use a service to manage the Switch. Click Access Control to return to the Access Control screen.

Figure 189 Management > Access Control > Remote Management

The following table describes the labels in this screen.

Table 130 Management > Access Control > Remote Management

LABEL

DESCRIPTION

Entry

This is the client set index number. A “client set” is a group of one or more “trusted

 

computers” from which an administrator may use a service to manage the Switch.

 

 

Active

Select this check box to activate this secured client set. Clear the check box if you wish to

 

temporarily disable the set without deleting it.

 

 

Start Address

Configure the IP address range of trusted computers from which you can manage this

End Address

Switch.

 

 

The Switch checks if the client IP address of a computer requesting a service or protocol

 

matches the range set here. The Switch immediately disconnects the session if it does not

 

match.

 

 

Telnet/FTP/

Select services that may be used for managing the Switch from the specified trusted

HTTP/ICMP/computers.
SNMP/SSH/

 

HTTPS

 

 

 

Apply

Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these

 

changes if it is turned off or loses power, so use the Save link on the top navigation panel to

 

save your changes to the non-volatile memory when you are done configuring.

 

 

Cancel

Click Cancel to begin configuring this screen afresh.

 

 

 

311

MES3500-24/24F User’s Guide