ZyXEL Communications MES3500-24, MES3500-24F 23.4.1 Port-based Q-in-Q, Port, Apply, Click, SPVID, Apply, Cancel, in the, Cancel, Priority, Chapter 9 on page, information on VLAN ID

	Chapter 23 VLAN Stacking
Table 57 Advanced Application > VLAN Stacking (continued)
LABEL	DESCRIPTION
Apply	Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
	changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
	your changes to the non-volatile memory when you are done configuring.
Cancel	Click Cancel to begin configuring this screen afresh.

23.4.1 Port-based Q-in-Q

Port-based Q-in-Q lets the Switch treat all frames received on the same port as the same VLAN flows and add the same outer VLAN tag to them, even they have different customer VLAN IDs.

Click Port-based QinQ in the Advanced Application > VLAN Stacking screen to display the screen as shown.

Figure 91 Advanced Application > VLAN Stacking > Port-based QinQ

The following table describes the labels in this screen.

Table 58 Advanced Application > VLAN Stacking > Port-based QinQ

LABEL	DESCRIPTION
Port	The port number identifies the port you are configuring.
SPVID	SPVID is the service provider’s VLAN ID (the outer VLAN tag). Enter the service provider ID (from
	1 to 4094) for frames received on this port. See Chapter 9 on page 97 for more background
	information on VLAN ID.
Priority	Select a priority level (from 0 to 7). This is the service provider’s priority level that adds to the
	frames received on this port.
	"0" is the lowest priority level and "7" is the highest.
Apply	Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
	changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
	your changes to the non-volatile memory when you are done configuring.
Cancel	Click Cancel to begin configuring this screen afresh.

	183
MES3500-24/24F User’s Guide