Chapter 4 Connection Wizard
Figure 28 Wizard Step 2: Wireless LAN
The following table describes the labels in this screen.
Table 9 Wizard Step 2: Wireless LAN
LABEL | DESCRIPTION |
Name (SSID) | Enter a descriptive name (up to 32 printable |
| LAN. |
| If you change this field on the ZyXEL Device, make sure all wireless stations use the |
| same SSID in order to access the network. |
|
|
Security | Select a Security level from the |
| Choose Auto to have the ZyXEL Device generate a |
| screen pops up displaying the generated |
| OK to continue. |
| Choose None to have no wireless LAN security configured. If you do not enable any |
| wireless security on your ZyXEL Device, your network is accessible to any wireless |
| networking device that is within range. If you choose this option, skip directly to |
| |
| Choose Basic (WEP) security if you want to configure WEP Encryption parameters. If |
| you choose this option, go directly to Section 4.3.1 on page 59. |
| Choose Extend |
| Choose this option only if your wireless clients support |
| respectively. If you choose this option, skip directly to Section 4.3.2 on page 60. |
|
|
Channel | The range of radio frequencies used by IEEE 802.11b/g wireless devices is called a |
Selection | channel. |
| Select a channel that is not used by any nearby devices. |
|
|
Back | Click Back to display the previous screen. |
|
|
Next | Click Next to proceed to the next screen. |
|
|
Exit | Click Exit to close the wizard screen without saving. |
|
|
"The wireless stations and ZyXEL Device must use the same SSID, channel ID and WEP encryption key (if WEP is enabled),
58 |
| |
ZyXEL |
| |
|
|
|