Chapter 25 Addresses

25.2 Address Commands Summary

The following table describes the values required for many address object and address group commands. Other values are discussed with the corresponding commands.

Table 102 Input Values for Address Commands

LABEL

DESCRIPTION

object_name

The name of the address. You may use 1-31 alphanumeric characters,

 

underscores(_), or dashes (-), but the first character cannot be a number. This

 

value is case-sensitive.

group_name

The name of the address group. You may use 1-31 alphanumeric characters,

 

underscores(_), or dashes (-), but the first character cannot be a number. This

 

value is case-sensitive.

interface_name

The name of the interface. Use gex, x = 1 ~ N for Ethernet interfaces, where N

 

equals the highest numbered Ethernet interface for your NXC model.

 

Use vlanx, x= 1 ~N for VLAN interfaces where N equals the highest numbered

 

Ethernet interface for your NXC model

 

 

The following sections list the address object and address group commands.

25.2.1 Address Object Commands

This table lists the commands for address objects.

Table 103 address-object Commands: Address Objects

COMMAND

DESCRIPTION

show address-object [object_name]

Displays information about the specified address or

 

all the addresses.

address-objectobject_name {ip ip_range

Creates the specified address object using the

ip_subnet interface-ip interface-subnet

specified parameters.

interface-gateway} {interface}

ip_range: <1..255>.<0..255>.<0..255>.<1..255>-

 

<1..255>.<0..255>.<0..255>.<1..255>

 

ip_subnet:

 

<1..255>.<0..255>.<0..255>.<0..255>/<1..32>

 

interface: You only need to specify an interface

 

with you create an object based on an interface.

 

 

no address-object object_name

Deletes the specified address.

address-object list

Displays all address objects on the NXC.

address-object rename object_name object_name

Renames the specified address (first

 

object_name) to the second object_name.

178

 

NXC CLI Reference Guide