ZyXEL Communications NOT AVAILABLE 36.1.5 Console Port Log Commands, 36.1.6 Access Point Logging Commands

Chapter 36 Logs

This table lists the commands for the console port settings.

Table 143 logging Commands: Console Port Settings

COMMAND	DESCRIPTION
show logging status console	Displays the current settings for the console log.
	(This log is not discussed above.)
[no] logging console	Enables the console log. The no command
	disables the console log.
logging console category module_name level	Controls whether or not debugging information for
{alert crit debug emerg error info	the specified priority is displayed in the console log,
notice warn}	if logging for this category is enabled.
[no] logging console category module_name	Enables logging for the specified category in the
	console log. The no command disables logging.

This table lists the commands for the Access Point settings.

For the purposes of this device’s CLI, Access Points are referred to as WTPs.

Table 144 logging Commands: Access Point Settings

COMMAND	DESCRIPTION
show wtp-logging status system-log [ap_mac]	Displays the system log for the specified AP.
show wtp-logging entries [priority pri]	Displays only the specified log entries for the
[category module_name] [srcip ipv4] [dstip	specified AP.
ipv4] [service service] [srciface
config_interface] [dstiface config_interface]
[protocol log_proto_accept][begin <1..512> end
<1..512>] [keyword keyword] [ap_mac]
show wtp-logging entries field	Displays only log entries for specified fields for the
{srcifdstifprototimemsgsrcdstnotepric	specified AP. You can display a range of field
atall} [begin <1..512> end <1..512>] [ap_mac]	entries from 1-512.
show wtp-logging debug status ap_mac	Displays the debug status of the specified AP.
show wtp-logging debug entries [priority pri]	Display only the specified debug log entries for the
[category module_name] [srcip ipv4] [dstip	specified AP.
ipv4] [service service] [srciface
config_interface] [dstiface config_interface]
[protocol log_proto_accept ] [begin <1..512>
end <1..512>] [keyword keyword] [ap_mac]
show wtp-logging debug entries field {	Displays only the log entries for the specified fields
srcifdstifproto	for the specified AP. You can display a range of
timemsgsrcdstnotepricatall} [begin	field entries from 1-1024.
<1..1024> end <1..1024>] [ap_mac]
show wtp-logging status syslog [ap_mac]	Displays the logging status for the specified AP’s
	syslog.