ZyXEL Communications NWA1100-N 11.4 IP Screen

Chapter 11 IP Screen

11.4 IP Screen

Use this screen to configure the IP address for your NWA. Click IP to display the following screen. Figure 51 IP Setup

The following table describes the labels in this screen.

Table 33 IP Setup

LABEL	DESCRIPTION
Obtain IP Address	Select this option if your NWA is using a dynamically assigned IP address
Automatically	from a DHCP server each time.
	Note: You must know the IP address assigned to the NWA (by the DHCP
	server) to access the NWA again.
Use Fixed IP Address	Select this option if your NWA is using a static IP address. When you select
	this option, fill in the fields below.
IP Address	Enter the IP address of your NWA in dotted decimal notation.
	Note: If you change the NWA's IP address, you must use the new IP address
	if you want to access the web configurator again.
Subnet Mask	Type the subnet mask.
Gateway IP Address	Type the IP address of the gateway. The gateway is an immediate neighbor
	of your NWA that will forward the packet to the destination. On the LAN,
	the gateway must be a router on the same segment as your NWA; over the
	WAN, the gateway must be the IP address of one of the remote nodes.
Spanning Tree	(R)STP (Section 11.5.2 on page 107) detects and breaks network loops and
	provides backup links between switches, bridges or routers. It allows a
	bridge to interact with other (R)STP -compliant bridges in your network to
	ensure that only one path exists between any two stations on the network.
	Select the check box to activate STP on the NWA.
Apply	Click Apply to save your changes.
Reset	Click Reset to begin configuring this screen afresh.

106
	NWA1100-N User’s Guide