Appendix H Legal Information
•This device complies with the requirements of Health Canada Safety Code 6 for Canada. (for USB wireless adapters or CardBus cards)
•Testing was performed on laptop computers with antennas at 0mm spacing. The maximum SAR value is: ??? W/kg. The device must not be collocated with any other antennas or transmitters. (For USB wireless adapters or CardBus cards. The SAR value may differ by model: check before adding this statement.)
•This equipment has been
•The device complies with FCC RF radiation exposure limits set forth for an uncontrolled environment, under 47 CFR 2.1093 paragraph (d)(2). End users must follow the specific operating instructions for satisfying RF exposure compliance. To maintain compliance with FCC RF exposure compliance requirements, please follow operation instruction as documented in this manual. (for USB wireless adapters or CardBus cards)
•This transmitter must not be
•For operation within 5.15 ~ 5.25GHz frequency range, it is restricted to indoor environment. (for IEEE 802.11a wireless devices)
•IEEE 802.11b, 802.11g or 802.11n(20MHz) operation of this product in the U.S.A. is firmware- limited to channels 1 through 11. IEEE 802.11n(40MHz) operation of this product in the U.S.A. is
•IEEE 802.11b or 802.11g operation of this product in the U.S.A. is
•To comply with FCC RF exposure compliance requirements, a separation distance of at least 20 cm must be maintained between the antenna of this device and all persons. (for all wireless devices without SAR test, such as an AP or wireless router. the SAR test will be done for wireless USB adapters and CardBus cards)
•Due to the essential high output power natural of WiMAX device, use of this device with other transmitter at the same time may exceed the FCC RF exposure limit and such usage must be prohibited (unless such
•SAR compliance has been established in typical laptop computer(s) with USB slot, and product could be used in typical laptop computer with USB slot. Other application like handheld PC or similar device has not been verified and may not compliance with related RF exposure rule and such use shall be prohibited. (for WiMAX USB adapters with SAR measurement)
Industry Canada Statement (For all products)This device complies with
1)this device may not cause interference and
2)this device must accept any interference, including interference that may cause undesired operation of the device
This device has been designed to operate with an antenna having a maximum gain of 2dBi.
Antenna having a higher gain is strictly prohibited per regulations of Industry Canada. The required antenna impedance is 50 ohms.
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the EIRP is not more than required for successful communication.
240 |
|
|
|