Chapter 15 Quality of Service (QoS)
15.3 The Class Setup Screen
Use this screen to add, edit or delete classifiers. A classifier groups traffic into data flows according to specific criteria such as the source address, destination address, source port number, destination port number or incoming interface. For example, you can configure a classifier to select traffic from the same protocol port (such as Telnet) to form a flow.
Click Advanced > QoS > Class Setup to open the following screen.
Figure 139 Advanced > QoS > Class Setup
The following table describes the labels in this screen.
Table 84 Advanced > QoS > Class Setup
LABEL | DESCRIPTION |
Create a new Class | Click this to create a new classifier. |
|
|
No | This is the number of each classifier. The ordering of the classifiers is important |
| as the classifiers are applied in turn. |
|
|
Active | Select the check box to enable this classifier. |
|
|
Name | This is the name of the classifier. |
|
|
Interface | This shows the interface from which traffic of this classifier should come. |
|
|
Priority | This is the priority assigned to traffic of this classifier. |
|
|
Filter Content | This shows criteria specified in this classifier. |
|
|
Modify | Click the Edit icon to go to the screen where you can edit the classifier. |
| Click the Remove icon to delete an existing classifier. |
|
|
Apply | Click this to save your changes. |
|
|
Cancel | Click this to restore your previously saved settings. |
|
|
15.3.1 The Class Configuration Screen
Use this screen to configure a classifier. Click the Add button or the Edit icon in the Modify field to display the following screen.
232 |
| |
| ||
|
|
|