Chapter 1 Introduction

 

 

 

 

 

 

 

Table 1

LED Descriptions

 

 

LED

 

COLOR

STATUS

DESCRIPTION

 

 

 

Green

On

The ZyXEL Device has an IP connection but no traffic.

 

 

 

 

 

Your device has a WAN IP address (either static or

 

(INTERNET)

 

 

assigned by a DHCP server), PPP negotiation was

 

 

 

 

 

successfully completed (if used) and the DSL

 

 

 

 

 

connection is up.

 

 

 

 

 

 

 

 

 

 

Blinking

The ZyXEL Device is sending or receiving IP traffic.

 

 

 

 

 

 

 

 

 

Red

On

The ZyXEL Device attempted to make an IP

 

 

 

 

 

connection but failed. Possible causes are no response

 

 

 

 

 

from a DHCP server, no PPPoE response, PPPoE

 

 

 

 

 

authentication failed.

 

 

 

 

 

 

 

 

 

 

Off

The ZyXEL Device does not have an IP connection.

 

 

 

 

 

 

Refer to the Quick Start Guide for information on hardware connections.

1.6 The RESET Button

If you forget your password or cannot access the web configurator, you will need to use the RESET button at the back of the device to reload the factory-default configuration file. This means that you will lose all configurations that you had previously and the password will be reset to “1234”.

1.6.1 Using the Reset Button

1Make sure the POWER LED is on (not blinking).

2To set the device back to the factory default settings, press the RESET button for ten seconds or until the POWER LED begins to blink and then release it. When the POWER LED begins to blink, the defaults have been restored and the device restarts.

 

25

P-660HN-T1H User’s Guide